Heat Treatment Technology and Equipment 2017 Vol.38 Issue 2

Journal Articles

Laws/Policies/Regulations

Companies/Products

17 Records Found

I could not find the article I request

热处理技术与装备
Heat Treatment Technology and Equipment

Year 2017 Volume 38

Issue 2

Nucleation and Growth of Bainite Phase Transformation——New Mechanism of Bainite Phase Transformation (1) (贝氏体相变的形核与长大——贝氏体相变新机制(一))

LIU Zong-chang, JI Yun-ping, REN Hui-ping

.................. page:1-7

Study on Ablation Property of SiC/Al-Mg Double Continuous Phase Composite (SiC/Al-Mg双连续相复合材料的烧蚀性能研究)

TU Jing-luo, YE Zhi-guo

.................. page:7-13

xin xi dong tai (信息动态)

.................. page:13,25,46,53,67-68

Structural Optimization on Ultra High Strength Mooring Chain of Grade R6 (超高强度R6级系泊链结构优化)

LI Jian, ZHU Qiao-liang, SHAO Yun-liang, ZHANG Ming

.................. page:14-18

Effect of Spheroidizing Annealing Microstructure on the Properties of SCM435 Bolt (球化退火组织对SCM435螺栓性能的影响)

WANG Li

.................. page:19-22

Research on Low Temperature Property of R5 Mooring Chain (R5级系泊链的低温性能的研究)

ZHANG Wei-xin

.................. page:23-25

Research on Extrusion Process of Thin-walled Profiles of the Low Volume Fraction SiC Reinforced Al Matrix Composites Material (低体积分数铝基碳化硅强化的复合材料薄壁型材挤压工艺研究)

GAI Hong-tao, WANG Dong, WANG Yan-jun, LIU Zhao-wei, WU Hai-xu, YU Chang-fu

.................. page:26-28

Technical Study on High Temperature Hot Stamping Steel Ball of Hot Rolled Unannealed Material (热轧未退火材高温热冲钢球工艺研究)

SUN Xiao-dong, WANG Yun-guang, SUN Wei

.................. page:28-30

Simulation Analysis on Quenching Deformation for the Internal Spline of Half Shaft Gear (半轴齿轮内花键淬火变形的模拟分析)

WANG Cai, XIE Li-xiang, HUANG Xing-xing, PAN Xiao-dong

.................. page:31-35

Research on Carburizing Process of Cyclic Changing Temperature for 20 Steel (20钢循环变温渗碳过程分析)

YU Ying-wei, JIANG Ke-quan, SHENG Guo-xi, LI Zhi-yong

.................. page:35-38

Improvement of the Cyaniding Process for Pin Shaft (销轴氰化工艺的改进)

LI Zhi-xue

.................. page:39-43

Application of Zero Flow Process in Vacuum Nitriding Furnace (零流量工艺在真空渗氮炉中的应用)

ZHAO Xiao-qiang

.................. page:43-46

Analysis on Surface Defect of Wind Power Bearing Blank Steel Ball (风电轴承毛坯钢球表面缺陷分析)

ZHANG Ling, ZENG Chao-fan, Sun Wei

.................. page:47-49

Failure Analysis of φ200 mm × 865 mm Supporting Roller (φ200mm×865mm支重轮轴开裂原因分析)

WANG Ning, WANG Yong, FENG Zhao-ping

.................. page:50-53

Cause Analysis and Reappearance Test for Not Quenching Parts in Finished Bearing (成品轴承零件中出现未淬火件的原因分析及再现试验)

YOU Lei-lei, DUAN MU Pei-lan, WANG Yan-shan

.................. page:54-57

Effect of Quenching Medium on Microstructure and Properties of 2Cr13 Quenching and Tempering Steel (淬火介质对2Cr13调质钢组织与性能的影响)

LI Rong-peng

.................. page:58-61

Quasicrystals, Quasicrystalline Solidification and It's Applications for Materials Engineering (2) (准晶、准晶凝固及其在材料工程上的应用(二))

ZHU Zu-chang, YANG Yi-tao, CHEN Si-yue

.................. page:61-66

Recommended Journals

Oriental Forum
青岛大学
1005-7110

Modern Agricultural Machinery

1674-5604

Urban Planning Forum
同济大学
1000-3363

Materials Science and Technology
中国材料研究学会哈尔滨工业大学
1005-0299

Household Appliance Technology
中国家用电器研究所中国轻工协会家用电器工程学会
1672-0172

Journal of Southwest University for Nationalities(Natural Science Edition)
西南民族大学
1003-2843

Transactions of Beijing Institute of Technology
北京理工大学
1001-0645

Chinese Journal of Energetic Materials
中国工程物理研究院
1006-9941

Measurement & Control Technology
北京长城航空测控技术研究所
1000-8829

Journal of Social Science of Jiamusi University
佳木斯大学
1007-9882